cAP ac-US

Dual-band 2.4 / 5GHz wireless access point for mounting on a ceiling or wall with two Gigabit Ethernet ports (one with PoE

output), 802.11ac support and IPsec hardware encryption support


Shipping cost (United States)

2nd Day Air: $1.50

2nd Day Air

Next Day Air: $1.50

Next Day Air

Next Day Air Saver: $1.50

Next Day Air Saver

Next Day Air Early AM: $1.50

Next Day Air Early AM

UPS Standard: $1.50

UPS Standard

The cAP ac is a competent and powerful wireless access point that looks beautiful on both walls and ceilings. The concurrent dual-band wireless radio supports dual chain 2 GHz 802.11b/g/n and 5 GHz in a/n/ас standards and will provide coverage in 360 degrees around it.


Even though the radio supports repeater mode, the two Ethernet ports give you the ability to extend your network with cables, also if PoE power is required since the cAP ac supports 802.3af/at PoE input on the first port and passive PoE output on the second port. The device supports IPsec hardware acceleration too.


- cAP ac (International) supports 2412-2484MHz and 5150MHz-5875MHz range (Country regulations can limit specific frequency range).

- cAP ac-US (USA) is factory locked for 2412-2462MHz, 5170-5250MHz and 5725-5835MHz frequencies. This lock cannot be removed.


Wireless specifications

2.4 GHzTransmit (dBm)Receive Sensitivity
1MBit/s26-100
11MBit/s26-94
6MBit/s26-96
54MBit/s23-78
MCS026-96
MCS722-73

5 GHzTransmit (dBm)Receive Sensitivity
6MBit/s26-96
54MBit/s21-80
MCS026-96
MCS720-75
MCS918-70


Ethernet test results

RBcAPGi-5acD2nDIPQ-4018 1G all port test
ModeConfiguration1518 byte512 byte64 byte
kbpsMbpskbpsMbpskbpsMbps
Bridgingnone (fast path)162.51973.4469.91924.71484.8760.2
Bridging25 bridge filter rules162.11968.5352.91445.5359.2183.9
Routingnone (fast path)162.51973.4469.91924.71488761.9
Routing25 simple queues162.51973.4469.91924.7506.3259.2
Routing25 IP filter rules162.21969.8240.8986.3242.9124.4
  1. All tests are done with Xena Networks specialized test equipment (XenaBay) and done according to RFC2544 (Xena2544)
  2. Max throughput is determined with 30+ second attempts with 0,1% packet loss tolerance in 64, 512, 1518 byte packet sizes
  3. Values in Italic indicate that max throughput was reached without maxing out CPU, but because board interface configuration was maxed out
  4. Test results show device maximum performance, and are reached using mentioned hardware and software configuration; different configurations most likely will result in lower results

IPsec test results

RBcAPGi-5acD2nDIPQ-4018 IPsec throughput
ModeConfiguration1400 byte512 byte64 byte
kbpsMbpskbpsMbpskbpsMbps
Single tunnelAES-128-CBC + SHA137.9424.559241.761.631.5
256 tunnelsAES-128-CBC + SHA136403.238.5157.739.820.4
256 tunnelsAES-128-CBC + SHA25636403.238.5157.739.820.4
256 tunnelsAES-256-CBC + SHA134.4385.337.9155.239.820.4
256 tunnelsAES-256-CBC + SHA25634.4385.337.9155.239.820.4
  1. All tests are done with Xena Networks specialized test equipment (XenaBay) and done according to RFC2544 (Xena2544)
  2. Max throughput is determined with 30+ second attempts with 0,1% packet loss tolerance in 64, 512, 1400 byte packet sizes
  3. Test results show device maximum performance, and are reached using mentioned hardware and software configuration; different configurations most likely will result in lower results



MikroTik
RBcAPGi-5acD2nD
New product
27 cm
18 cm
7 cm
1 kg
7540000000844
Data sheet
10/100 Ethernet ports
2
CPU
IPQ-4018
Product code
RBcAPGi-5acD2nD
Architecture
ARM 32bit
CPU core count
4
CPU nominal frequency
716 MHz
Dimensions
Round case: ⌀ 136 mm, height: 30 mm; Square case: 145 mm x 145 mm x 30 mm
License level
4
Operating System
RouterOS
Size of RAM
128 MB
Storage size
16 MB
Storage type
FLASH
Tested ambient temperature
-40 to 50° C
Max Power consumption
13
PoE in
802.3af/at
PoE out
Passive PoE up to 57V
PoE in input Voltage
17-57 V
Number of DC inputs
1 (PoE-IN)
Wireless 2.4 GHz number of chains
2
Wireless 2.4 GHz standards
802.11b/g/n
Antenna gain dBi for 2.4 GHz
2
Wireless 2.4 GHz chip model
IPQ-4018
Max out per port output - input (less than 30 V)
500 mA
Max total out (A)
500 mA
Max power consumption without attachments
13W
Max out per port output (input more than 30 V)
400 mA
Wireless 5 GHz number of chains
2
Wireless 5 GHz standards
802.11a/n/ac
Antenna gain dBi for 5 GHz
2.5
Wireless 5 GHz chip model
IPQ-4018

You might also like