mAP

mAP

Dual-Chain 2.4GHz micro AP, 650MHz CPU, 64MB RAM, 2xEthernet, PoE out

$45.00
Back-Order, Contact us for the ETA
 Product available for orders

The mAP (micro Access Point) is a tiny size wireless Dual-Chain 2.4GHz Access Point with full RouterOS capabilities. It is very portable, since it accepts power from a wide variety of sources - USB, Passive PoE and power jack. It also works as a PoE injector - the second Ethernet port provides up to 500mA of power to another device, for example, you can connect a SXT CPE device to it.

Wireless specifications

2.4 GHzTransmit (dBm)Receive Sensitivity
1MBit/s 22 -96
11MBit/s 22 -89
6MBit/s 20 -93
54MBit/s 18 -74
MCS0 20 -93
MCS7 16 -71

Ethernet test results

RBmAP2nD QCA9531 100M two port test
Mode Configuration 1518 byte 512 byte 64 byte
kpps Mbps kpps Mbps kpps Mbps
Bridging none (fast path) 16.3 197.9 47.0 192.5 297.6 152.4
Bridging 25 bridge filter rules 16.3 197.9 47.0 192.5 80.4 41.2
Routing none (fast path) 16.3 197.9 47.0 192.5 233.1 119.3
Routing 25 simple queues 16.3 197.9 47.0 192.5 131.4 67.3
Routing 25 ip filter rules 16.3 197.9 47.0 192.5 49.1 25.1
  1. All tests are done with Xena Networks specialized test equipment (XenaBay),and done according to RFC2544 (Xena2544)
  2. Max throughput is determined with 30+ second attempts with 0,1% packet loss tolerance in 64, 512, 1518 byte packet sizes
  3. Values in Italic indicate that max throughput was reached without maxing out CPU, but because board interface configuration was maxed out
  4. Test results show device maximum performance, and are reached using mentioned hardware and software configuration, different configurations most likely will result in lower results

RBmAP2nD
6.80 cm
6.80 cm
1.90 cm
Data sheet
CPU
QCA9531
Product code
RBmAP2nD
Architecture
MIPSBE
CPU core count
1
CPU nominal frequency
650 MHz
Dimensions
68x68x19mm
License level
4
Operating System
RouterOS
Size of RAM
64 MB
Storage size
16 MB
Storage type
FLASH
Tested ambient temperature
-10C to +70C tested
Max Power consumption
5
PoE in
802.3af/at
PoE out
Passive PoE
PoE in input Voltage
12-57 V
Number of DC inputs
3 (DC jack, MicroUSB, PoE-IN)
DC jack input Voltage
8-57 V
10/100 Ethernet ports
2
Number of USB ports
1
USB Power Reset
Yes
USB slot type
microUSB type AB
Max USB current (A)
1
Voltage Monitor
Yes
PCB temperature monitor
Yes
Wireless 2.4 GHz number of chains
2
Wireless 2.4 GHz standards
802.11b/g/n
Antenna gain dBi for 2.4 GHz
1.2
Wireless 2.4 GHz chip model
QCA9531
Max out per port output - input (less than 30 V)
0.5 A
Max total out (A)
0.5 A
Max power consumption without attachments
5W
MicroUSB input Voltage
5-5 V
Max out per port output (input more than 30 V)
0 mA